Jimdaboe
join:2001-01-16
Corpus Christi, TX | reply to jpsimon1978
Re: Trouble Installing
Raspppoe uses Dial up networking to make the connection. Make sure it is installed. if it is try uninstilling, reboot and reinstall. It is in Add/Remove programs, Windows setup, communications. It worked for me! |
|
columb
@deuba.com
| reply to jpsimon1978
Hello.
I'm having the same problem:
Everything when just as per the instructions and I got a message similar to 'no response'
Instead of thinking this could be due to t-online not switching the service on yet I thought it could be due to
my laptop using a 3com combi card . So i decided to reinstall with the 3com patches
First though I unistalled your ppp over ethernet driver and deleted the DDL file from the sys32 dir
However, now when I try and create a dial-up connection after the re-installation (i.e. start->run->raspppoe)
I get the message box 'NO DIAL UP SERVICES FOUND' 'Could not find any dial-up devices exposed by the PPP over ethernet protocol'
I get this message again and again. I have removed the driver and resinstalled it without the 3com patch but still the same message.
I have also noted the 'known issues' section which describes problems with unbinding and removing the ppp protocol and have tried the
the workarounds but with no luck PLEASE HELP. |
|
jpsimon1978
join:2003-05-25
South Bend, IN | reply to Bob Carrick
My connection does work by the way! I just wanted to install this since I heard it works better than Enter300 software. So I don't know how to fix it based on what you said but I hope you will help, thanks! |
|
Bob Carrick
Premium,ExMod 2002
join:2000-04-24
New York, NY | reply to jpsimon1978
You don't know if your connection even works? Then why are you installing RASPPPoE?
Run through your installation guide from your ISP with their software etc. |
|
jpsimon1978
join:2003-05-25
South Bend, IN | reply to jpsimon1978
Well how the heck do you do that? I need detailed help, not just a one sentence solution! I'm not that good with computers, know more than I did but still learning too, OK? Thanks! |
|
Bob Carrick
Premium,ExMod 2002
join:2000-04-24
New York, NY | reply to jpsimon1978
You need to confirm your Ethernet card is connected to your modem and the connection itself works. |
|
jpsimon1978
join:2003-05-25
South Bend, IN
|  I just downloaded this Software from the Website provided and Unzipped it but got the following Error message: No Dial-Up Devices Found
Could not find any dial-up devices exposed by the PPP over Ethernet Protocol. If you have not rebooted since installing the protocol, please do so now. If you already have rebooted since, try reinstalling the protocol.
I already did reboot and it hasn't helped the situation. What can be done to solve this annoying error message? Please help me, thanks! |
|
