Installation progressing - dslreports.com

Author

All Replies

vincent9993

join:2001-08-14
Montreal, QC

reply to vincent9993
Installation progressing

Location of entry point for Internet
Setup of the networking equipment

The decision has been made. We are getting electricity installed on the vacant lot next to the neighbour in the above picture. I have configured the bridge and router, it's ready to go in. I hope to hear back from our cable company this week. We are going to build a steel box and insulate it. I am hoping that the heat generaged from the modem, AP and power supplies will be enough to keep it above zero degrees C. I figure if I make the box about 1 foot square and insulate it with 2" styrofoam I should be OK. A telephone pole is being installed to accomodate the power company's entry. We will mount the Modem, AP and power outlet on that same pole.

to forum · permalink ·

· 2003-11-25 07:28:54 · (locked)

bdubyaah

@comcast.net

If your going to have electricity in the box just wire in a small light. Plenty of heat to keep it from freezing.

to forum · permalink · 2003-11-25 18:37:13 · (locked)

vincent9993

join:2001-08-14
Montreal, QC

Thought about that but I'll have to make sure it does not burn out! Light bulbs tend to not like temperature variations too much!

to forum · permalink ·

· 2003-11-25 18:43:46 · (locked)


Sunday, 08-Nov 22:48:04	Terms of Use \| Privacy Policy \| Hosting by www.nac.net - DSL,Hosting & Co-lo \| feedback \| contact over 10 years online! © 1999-2009 dslreports.com. page compression OFF