ToasterMan78
Premium
join:2003-11-26
3 edits | reply to I_Route
Re: 831 out-of-box config??
said by I_Route  :
... do a write erase and reload, the default config will then be there.
If I understand correctly, the write erase command would erase the startup-config in NVRAM, and then, on reload, the IOS software image in flash would create a default running-config in SDRAM?
The reason I ask is because I believe I did this once, and the "default" running-config that was created seemed minus a lot of the stuff in the config that came with the router out of the box.
I mention this because I have a saved running-config for 12.2(13) and also for 12.3.4 for the Cisco 831 router - I don't know if it would help or hurt if mhendren attempted to run it. If he took one of my configs, couldn't he do a copy tftp running-config and wouldn't this parse/merge the two running-config's and reject any erroneous commands in my config file and leave him with a good running-config? |
|
I_Route
Premium,VIP
join:2003-09-19
Merrimack, NH
| quote:
The reason I ask is because I believe I did this once, and the "default" running-config that was created seemed minus a lot of the stuff in the config that came with the router out of the box.
If you havd some stuff in the config when you got it then it is possible you got a unit that may have been tested. Did you buy your router new or was it a refab?
All boxes I have gotten new have had no "extra" commands. If I were to do a write-erase then there would be no less info than from when it was new.
Later,
Jeff |
|
ToasterMan78
Premium
join:2003-11-26
2 edits | said by I_Route :
If you havd some stuff in the config when you got it then it is possible you got a unit that may have been tested. Did you buy your router new or was it a refab?
A new Unit.
BTW I did a write erase on my own router to try your suggestion and a default config was created which did not allow me internet access or to even ping the router [I had to struggle to set up dchp settings (as I am a newbie at this) and to configure the interface(s) from down to up] - finally I set up the dchp server on the router so I could communicate with it, set the interfaces from down to up and I was able to tftp my saved config back to the router and get things back to normal. The config that comes shipped with the router is different than the default config created from a write erase - the out-of-box config it allows you to basically plug in the connections to the router and go, not have to get interfaces up and configure the dhcp server on the router.
But it was educational for me - I got to configure dchp on the router heh! |
|
