Steve75
@verizon.net
|  reply to steve75
Re: Problems Installing RASPPPOE in W2K Adv Server
Hi Bob,
Thanks for the prompt Feedback to my questions.
After several re-installs of RASPPPoE I gave up and obtained a copy of WinPoet which then seemed to suffer from similar problems.
After many frustrating hours I decided to cut my losses and Installed a clean copy of W2K advanced server on a spare Hard Disk and I now have RASPPPOE working, yay 
I now have to try and configure my system to share the connection on my network.
Previously with my cable modem I used NAT to route all the TCP/IP traffic to the cable modem.
Will I be able to do this with RASPPPOE? I have read a few posts on using ICS but I would like to have the control provided by W2K's NAT routing interfaces.
Steve |
|
Bob Carrick
Premium,ExMod 2002
join:2000-04-24
New York, NY | Sharing works just fine with PPPoE. I have instructions for all of that at my site where you posted this question originally. |
|
Steve75
@verizon.net | Do you really? I could only find an article on ICS on Windows 2000 Professional systems. I could not find anything on setting up routing with NAT on Windows 2000 servers.
Could you give me the link to the said article.
Steve |
|
rock reynolds
| Hi everybody!
I have tried installing raspppoe on 3 different Windows 2000 Advanced Server installations and I have gotten the same error message:
"Could not install requested components. Error is 0x800700C1"
The last install was fresh with one NIC. I tried with both SP4 and without SP4.
Any recommendations?
Thanx.
Roger Reynard
aka Rock Reynolds |
|
rock reynolds
| reply to Steve75
Hi eberybody!
I have tried installing raspppoe on 3 different Windows 2000 Advanced Server installations and I have gotten the same error message:
"Could not install requested components. Error is 0x800700C1"
The last install was fresh with one NIC. I tried with both SP4 and without SP4.
Any recommendations?
Thanx.
Roger Reynard
aka Rock Reynolds |
|
