bbarrera
Premium,MVM
join:2000-10-23
Sacramento, CA
clubs: | Re: FreeRADIUS/WinXP Authentication Setup Any particular reason you used CVS snapshot of FreeRadius instead of version 0.9.3 released in November? | |
|
 
No_Strings
Premium,Mod
join:2001-11-22
The OC | Re: FreeRADIUS/WinXP Authentication Setup PEAP is not available in the released version.
Rumblings on the freeradius mailing list indicate that a 1.0 release is fairly close.
--
I will not take other people's medicine. | |
|
 |
bbarrera
Premium,MVM
join:2000-10-23
Sacramento, CA
clubs: | Re: FreeRADIUS/WinXP Authentication Setup Thanks. Assume FreeRadius 0.9.3 is OK for TLS. Wasn't planning on using PEAP so I'll give the latest release a try. | |
|
| |
No_Strings
Premium,Mod
join:2001-11-22
The OC | Re: FreeRADIUS/WinXP Authentication Setup TLS is indeed included in 0.9.3. Running here.
--
I will not take other people's medicine. | |
|
| | jbibe
Premium,MVM
join:2001-02-22
| If you only need TLS, you can use FreeRadius-0.9.3 and OpenSSL-0.9.7c, both stable releases. Since FreeRadius-0.9.3 does not support "--with-openssl/include=" and "--with-openssl-libraries=", you will need to use:
./configure --prefix=/usr/local/radius
After configure executes, edit the rlm_eap_tls Makefile as shown in the Document 3. Then perform
make
make install
In the users file, you will need to enter the Auth-Type, as follows:
jbibe Auth-Type := EAP
Also, you will need to verify that the information in the Authorization section of radiusd.conf file matches the information in Document 3.
If you follow the How-To advice in Document 3, you do not need to download and install two OpenSSL versions. OpenSSL-0.9.7c will support the creation of the required certificates and the operation of FreeRadius-0.9.3. | |
|
| | |
bbarrera
Premium,MVM
join:2000-10-23
Sacramento, CA
clubs: | Re: FreeRADIUS/WinXP Authentication Setup Thanks!  | |
|
|
|
|
