bbarrera
Premium,MVM
join:2000-10-23
Sacramento, CA
clubs: | reply to jbibe
Re: FreeRADIUS/WinXP Authentication Setup
Thanks!  |
|
jbibe
Premium,MVM
join:2001-02-22
| reply to bbarrera
If you only need TLS, you can use FreeRadius-0.9.3 and OpenSSL-0.9.7c, both stable releases. Since FreeRadius-0.9.3 does not support "--with-openssl/include=" and "--with-openssl-libraries=", you will need to use:
./configure --prefix=/usr/local/radius
After configure executes, edit the rlm_eap_tls Makefile as shown in the Document 3. Then perform
make
make install
In the users file, you will need to enter the Auth-Type, as follows:
jbibe Auth-Type := EAP
Also, you will need to verify that the information in the Authorization section of radiusd.conf file matches the information in Document 3.
If you follow the How-To advice in Document 3, you do not need to download and install two OpenSSL versions. OpenSSL-0.9.7c will support the creation of the required certificates and the operation of FreeRadius-0.9.3. |
|
No_Strings
Premium,Mod
join:2001-11-22
The OC | reply to bbarrera
TLS is indeed included in 0.9.3. Running here.
--
I will not take other people's medicine. |
|
bbarrera
Premium,MVM
join:2000-10-23
Sacramento, CA
clubs: | reply to No_Strings
Thanks. Assume FreeRadius 0.9.3 is OK for TLS. Wasn't planning on using PEAP so I'll give the latest release a try. |
|
No_Strings
Premium,Mod
join:2001-11-22
The OC | reply to bbarrera
PEAP is not available in the released version.
Rumblings on the freeradius mailing list indicate that a 1.0 release is fairly close.
--
I will not take other people's medicine. |
|
bbarrera
Premium,MVM
join:2000-10-23
Sacramento, CA
clubs: | reply to jbibe
Any particular reason you used CVS snapshot of FreeRadius instead of version 0.9.3 released in November? |
|
