 
Trinijoy
Premium
join:2005-09-12
Brick, NJ | Check your ethernet card... Check your ethernet card settings and make sure the Ethernet card is not on half-duplex mode. Also try a new ethernet card, sometimes the ethernet card can be hurting your speeds, if it's older or even if it's defective. | |
|
 | 
AR
Premium,ExMod 2001-04
join:2000-09-21
Toronto, ON | Re: Check your ethernet card... I only use a Dell notebook. It works fine everywhere else. | |
|
bohn
join:2006-05-30
Scarborough, ON | Rogers Dropped The Newsgroups A Long Time Ago There is no news server or newsgroups with rogers cable internet. | |
|
|
AR
Premium,ExMod 2001-04
join:2000-09-21
Toronto, ON | Re: Rogers Dropped The Newsgroups A Long Time Ago I had acknowledged that but I have now amended my review to remove that statement. | |
|
Kegger_CDN
join:2002-08-18
London, ON
 ·Rogers Hi-Speed
1 edit | Tell Rogers what to do I am assuming the technician that came to your house (they did come to your house right ?) did the following:
Ensure proper connection:
- Cable run off tap directly to your service panel
- 1.5Ghz 2 way splitter to split off cable TV service and Internet service
- Cable from out on splitter directly to in on your modem, no wall outlets, couplers, splitters or any other breaks a straight run (so you have a small hole in your floor where it runs into your computer room)
- For TV I would get the other out to go into a 15Db amp with 4 outputs and each of those outputs going to your TVs - in this case pretty wall plates are acceptable
- Test the signal at the tap to ensure it is up to par and nothing is wrong down the line
- Test the signal on your service panel where it goes into the in on the 2 way splitter - if not up to par they will have to replace that entire cable from the tap to your service panel - I had to have this done as my house is over 20 years old - they have to dig a little track in your lawn
- Test the signal at the end of the cable where it goes to the in on your modem
Now, assuming this is all OK, ask them for a modem swap. I have had 2 exact same scenarios where swapping the modem solved the problem, and 1 where the modem was connected to the OUT on the amplifier instead of being split off before the amplifier to the TVs
Both cases were on the 3Mbps service and throughput was less than 1Mbps and tech support said this was within specification - after swapping the modems throughput went to 2.7-2.8Mbps and by not going through the out on the amplifier drop outs disappeared
In all cases the modems were the old Teryon grey battleship ones with fins - I upgraded to a Motorola SB5100 (not sure what their latest is now) and get 9.9Mbs on their 10Mbps service
And although I think you said you already did from a previous post, connect your machine's ethernet directly to the modem thus eliminating any other possible links, and if you have another ethernet cable use it instead
I hope this helps, but if you are in an apartment building I have no idea how they would do that | |
|
|
AR
Premium,ExMod 2001-04
join:2000-09-21
Toronto, ON | Re: Tell Rogers what to do Hi Kegger,
Which of my reviews are you responding to? My 2008 service is quite ok.  | |
|
| | Kegger_CDN
join:2002-08-18
London, ON | Re: Tell Rogers what to do Hi AR, I was replying to your original post without seeing the "have no problems" in your update #3 - glad to hear it.
Oh well maybe someone will find that post useful if they are not getting anywhere near the advertised throughput. | |
|
| | |
AR
Premium,ExMod 2001-04
join:2000-09-21
Toronto, ON | Re: Tell Rogers what to do Thumbs up for your contribution! | |
|
|
|
|
