ZyXEL → Zyxel P-2602hw-d1a. No connection between WLAN and LAN

Hi Experts.
I have a P2602HW-D1A wireless router with a build-in 4 port switch (LAN).
It's running the latest firmware 3.40 from 2008.

I can't get any connection between the LAN and WLAN.

I have disabled all firewalls (in the router and the connected PC's).

I have the router configured as DHCP-server and all connected PC's get the right IP-addresses ect.

All connected PC's can access the internet without any problems.

But when I try to ping a PC on the LAN (connected via cable) from a PC on the WLAN, I get no reply. And visa versa.

I even tried to make a firewall-rule in the router that allows all LAN-LAN traffic, even though i didn't enable the firewall. Still no luck.

Is the router defect ?

Hope you can help.
Steffen

Anyone ??

Additional info :
I can ping between two PC's on the wired LAN.
I can ping between two PC's on the wireless WLAN.

But still no dataflow between LAN and WLAN.

Please help.

Sthh

By default is, for security reasons, no traffic possible between WLAN and LAN. You need to enable this yourself.

Telnet to the router and enter the following 3 commands:

sys general load 1
sys general bridge on
sys general save

Bwuutje.

Thanks Bwuutje.

I will try your solution ASAP.
I'll be back with the result.

sthh.

Status report :

It works 100%.
With the solution from Bwuutje, WLAN and LAN are connected.

From a google-search, I only thought that this solution was valid for P660 routers, but it also works on the P2602.

Thanks again Bwuutje.

bwuutje what you mean with, telnet to the router? :s

Hi Jahu

Open a command-window (start-run-cmd-enter)
Type : telnet 192.168.1.1
If the router has another ip-address, use that instead.

Then you have to type the password for the router.
After you logged in, you can type the commands :
sys general load 1
sys general bridge on
sys general save

Hope it works for you.
sthh