said by rody:
take the splitter out of the tv card and i bet it will be fine. its common knowledge that splitting the line twice causes that excact problem. and just because it worked before doesnt mean it will work now your cable entering your house degrades over time. never split your modem signal now that is common knowledge 101. just because a 8 cylinder engine will run on 7 does not mean everything is good 101
I run my cable modem and WINTV card off a dedicated run from the initial splitter off my tap.
As long as the initial home run is a clean one with acceptable signal levels, this can be done.
Here are my current signal levels :
Downstream Value
Frequency 723000000 Hz Locked
Signal to Noise Ratio 33 dB
QAM 64
Network Access Control Object ON
Power Level -1 dBmV The Downstream Power Level reading is a snapshot taken at the time this page was requested. Please Reload/Refresh this Page for a new reading
Upstream Value
Channel ID 1
Frequency 30992000 Hz Ranged
Ranging Service ID 630
Symbol Rate 1.280 Msym/s
Power Level 45 dBmV
